4 results (0,14327 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

EFXN525 JSB Rate Of Rise Heat Detector

EFXN525 JSB Rate Of Rise Heat Detector

JSB Rate Of Rise Heat DetectorJSB Rate of rise detectors for use with JSB EFX2200 series fire panels. Rate of rise detectors are triggered either by a sudden rise in temperature of if the temperature rises to a fixed upper limit even if the rate of increase has been slow. These kinds of detectors are most suitable for areas where the temperature is normally stable and a fast reaction to sudden temperature change is required. NB the detector requires a separate mounting base which must be ordered separately.FeaturesLPC approvedLow profile designLocking facility360O viewing angle LED

GBP 17.48
1

EFXN524 Conventional Heat Detector JSB

EFXN524 Conventional Heat Detector JSB

EFXN524 Conventional Heat Detector JSBThe JSB range of conventional detectors have been specifically designed to operate with JSB control panels. The JSB optical detector FXN533 is suitable for most applications giving the fastest response to slow burning or smouldering fires which give rise to large visible smoke particles. The JSB photo-thermal detector FXN632 will respond quickly to fast clean burning fires yet maintain the advantage of optical detectors when detecting smouldering fires. The thermal enhancement of this detector allows a higher alarm threshold which provides a greater rejection of false alarms. The detector will also raise an alarm at temperatures exceeding 60C.The JSB fixed heat detectors FXN524 and FXN526 will detect temperatures above 77C and 92C. The rate of rise heat detector FXN525 is used to detect rapid increases in temperature with a maximum threshold of 60C. These detectors are designed to be used in environments where the ambient conditions might cause false alarms if smoke detection were to be used for example where there is a high level of dust fumes steam or smoke under normal conditions.Key Features Quick and simple to installStylish low profile design360 viewable LEDRemovable detector chamberDrift compensation

GBP 17.32
1

EOLM-1 JSB End Of Line Module Conventional Circuits

EOLM-1 JSB End Of Line Module Conventional Circuits

EOLM-1 JSB End Of Line Module Conventional CircuitsEach Zone on the panel that is configured for Standard Conventional mode must have the intelligent end of line module EOLM-1 fitted to continually monitor each zone for the presence of fault conditions such as detector head removal open or short circuit and for end of line failures even when in a Fire condition. The EOLM-1 module can be placed into the base of the last manual call point or detector base.

GBP 5.51
1